- Cal Information ECU Identification -
- Auto to manual conversion - Unofficial Honda FIT
- P28 Automatic or 5 Speed - YouTube
- Auto to Manual Moates Support
Cal Information ECU Identification -
Mods: AEM Intake & Cam Sprockets , RC Throttle Body, Greddy SS Header , RSR Exhaust , Carsound Cat , ACT Clutch & Fly, NGK 8mm Blue Wires, JDM Type-S Valve Cover , Koni Yellow Shocks , RSR Down Springs, Nuespeed Short Shift Adapter, CF Dashkit, CF 4th gen Auto to Manual Transmission Conversion Parts List: Transmission Flywheel Clutch assembly Slave cylinder Clutch master cylinder All lines and dampener from master to slave cylinder Includes-- line from master cylinder to dampener dampener, bracket and bolts to hold to fender rubber line from dampener to adapter on transmission adapter and bolt to hold to transmission line from adapter to slave cylinder bolt that holds rubber line to adapter(banjo-bolt) Starter for manual tranny Drivers side CV shaft and intermediate shaft Transmission mount and bracket Front motor mount(at radiator) Rear motor mount(at firewall) Speedometer sensor (salvage yard may leave it on the tranny) Shifter cables, holding clips, clevis pins and cotter pins Shifter cable bracket for tranny (salvage yard may leave it on the tranny) Shifter assembly Shifter boot assembly and shift knob Clutch pedal assembly Both switches for clutch and their plug-in connectors Brake and gas pedal assembly 30 Amp Relay Manual ECU Bolts Needed Transmission bolt that goes through starter and bolt below it(the two longest bolts) Flywheel bolts Pressure plate bolts Slave cylinder bolts Intermediate shaft hanger bolts Transmission shifter bracket bolts Step-by-Step To begin, disconnect the battery and disable the driver's side and passenger side (if equipped) airbags.
Auto to manual conversion - Unofficial Honda FIT
To do this, unplug the airbag wiring harness located behind a panel on the bottom side of the steering wheel and behind the glovebox for passenger airbag equipped cars.
P28 Automatic or 5 Speed - YouTube
To remove the shafts, take off the axle nuts and disconnect the lower control arms.
Auto to Manual Moates Support
Lhtly bump the shafts with a rubber mallet to extract them from the wheel bearing assembly.
Auto to manual ecu honda:
Rating: 93 / 100
Overall: 90 Rates